Connection; Set Up - Atlona AT-HDVS-200-TX User Manual

RS-232

Connection

RS-232 pin out is determined by the connected
device and connects as RX
and .
(ground)
Note: Be sure to follow the connect order above as
the female captive screw connector connects \
to the unit upside down.
RS-232 is often connected through a DB 9-pin to captive screw
connector. The pins have specific signals associated with them,
some are unassigned.
Note: Typical DB9 connectors use pin 2 for TX, pin 3 for RX, and pin 5
for ground. On some devices, the functions of pins 2 and 3 are
reversed.

Set Up

To set up the RS-232 terminal
1. Connect the HDVS-200 to a PC using a DB9 to DB9 and DB9 to USB adaptor cable
Note: A gender changer and/or null modem may be needed between some connections
a. Remove the DB9 connector, strip and connect the wires to the included captive screw
connector
2. Go to the Device Manager folder
3. Find the HDVS-200 COM port and right click with a mouse and select properties
Note: If unsure which COM port is the HDVS-200, unplug the cable and plug it back in. It will disappear and
reappear on the COM port list.
4. Under the properties menu select the port settings tab and update the menu to the HDVS-200
default settings of: Bits Per Second: 115200, Data Bits: 8, Parity: None, Stop Bits: 1 and
Flow Control: None.
Set up is done and any terminal program may be used to control the HDVS-200 now.
atlona.com
, TX
(receiver)
(See picture 1)
(if not using 3rd party software)
, then connect the captive screw connector to the switcher
(as explained above)
(see picture A)
(see picture C)
A
RS-232
TX
,
(transmitter)
use the following steps:
B
16
Wire color
1
differs by cable
RX
manufacturer.
5 4 3
9 8
Toll free: 1-877-536-3976
Local: 1-408-962-0515
2 1
7 6
(see picture B)
C