Webgui; Network Connections - Atlona AT-HDVS-200-TX User Manual

Network Connections

For convenience, the HDVS-200 comes with DHCP on. This enables the switcher to be connected
to a network without knowing available IP addresses. If your network does not allow dynamic IP
addresses or if you are using the switcher with a TCP/IP control system, this feature may be turned
off and the IP address set using RS-232 commands or the webGUI.

WebGUI

Atlona has created an easy to use webGUI for setup and changes to the configuration of the
HDVS-200.
To begin, plug a LAN cable into the LAN port of the HDVS-200 and the network switch, then type
the IP address of the unit into a web browser of a PC connected to the same network
To find the switcher IP: use RS-232 command "IPCFG".
Note: IP addresses may also be found using common free IP scanner software such as "Advanced IP Scanner"
*Atlona does not assume responsibility for damage caused by other programs installed onto a computer, verify programs before installing*
Important:
If any stability issues are experienced, disable any anti-virus or firewall that may interfere with
network communication to the switcher. Once set up is done and the switcher webGUI is no
longer being used, the firewall and anti-virus can be re-enabled.
A login screen will appear
the username is "root" and password is "Atlona".
admin changes)
Note: Only the admin password can be changed (see page 13). The username will always remain "root".
The Info Page displays general system information.
Note: When connected to a receiver other than the HDVS-200-RX it will display GENERAL in the
navigation bar.
atlona.com
(this is the same log in for admin and general users)
6
(as seen below)
. For the first log in
(and future
Toll free: 1-877-536-3976
Local: 1-408-962-0515
.