Atlona AT-HDVS-200-TX User Manual page 15

Network: IP address, netmask, gateway, and telnet port can be set to any settings compatible
with your network. The Netmask and Gateway must match your existing network
settings
IP Mode -
Static: Set a fixed IP address
Note: For a stable connection when using a control system, it is best to set up a static IP. As you select
an IP address, make certain no other devices on your network are using that IP address
DHCP: Dynamic Host Configuration Protocol will automatically select an IP address
on the network that is not already in use
Telnet Login Mode - Turn on/off - requires a password to adjust settings
Telnet Timeout - Set the auto log-off time between 1 and 3600 seconds
Broadcast - Turn on and off the feedback through all control ports
Reset to Default - Reset the device to factory settings
Firmware Update - Use this feature to find and load the MCU firmware to the switcher
Note: Firmware can be found and downloaded from http://www.atlona.com/products/AT-HDVS-200-TX/
page under the firmware tab
Valens Update - Use this feature to find and load the HDBaseT chip firmware to the switcher
atlona.com
15
Toll free: 1-877-536-3976
Local: 1-408-962-0515