IDE Device Connectors
The two connectors, IDE1 (PRIMARY)
and IDE2 (SECONDARY), are used for
your IDE hard disk drives, CD drives,
LS-120|drives, or IDE ZIP drives.
Insert the floppy ribbon cable
(below) onto the floppy connector.
The colored stripe (indicated by the
arrow head, right) of the ribbon cable
must be the same side as Pin 1.
Power Connectors
The 20-pin male block connector is connected to the ATX power supply. The
4-pin male block connector is for the ATX_12V power supply. Both connec-
tors are linked with your ATX power supply. The plug from the power supply
can only be inserted in one orientation because of the different hole sizes. Find
the proper orientation and push down firmly making sure that the pins are
aligned.
Installation Procedures
2 - 9