Table of Contents
Advertisement
Installation Procedures
IDE HDD Device Connector: PRIMARY and SECONDARY
These two 40-pin block connectors are used for your IDE hard disks. If you
have one IDE hard disk, connect it to the PRIMARY connector using the IDE
HDD flat cable provided with the mainboard. The BIOS auto detection sets it
to be a Primary Master disk. If you want to install another IDE hard disk or
CD-ROM, please use the SECONDARY connector. If two hard disks are
connected to the PRIMARY connector using the same cable, one of them is the
master drive, the other one is the slave drive. You may need to set jumpers for
the slave drive; please refer to the HDD manual for details.
Infrared Connector: IR
This 10-pin male connector is used for connecting to the infrared (SIR) port
and allows transmission of data to another system which also supports the SIR
feature.
43
Advertisement
Table of Contents
