FIC K7M-400A Instruction Manual page 51

Soft-Off by PWRBTN
The selection Delay 4 Sec. will allow the system shut down after 4 seconds
after the power button is pressed. The selection Instant-Off will allow the
system shut down immediately once the power button is pressed.
The settings are: Delay 4 Sec, Instant-Off.
Run VGABIOS if S3 Resume
This feature allows you to decide the way that VGA BIOS should be called
when the system resumes from an S3 state, if the above feature is set at S3
(PTR) or S1&S3. The options are Auto, Yes, No.
Ac Loss Auto Restart
When the system is shut down owing to the power failure, the system will
not be back to power on by itself. This feature allows you to set the
system back to which power status of the system when the system power
is resumed. It always will be back to on if set at On. The system always be
back to off if set at Off. The options are Auto, On, Off.
IRQ/Event Activity Detect
USB Resume from S1-S3
This item allows you to wake-up the system by USB device when you save
the computer power at S1-S3. The options are: Enabled, Disabled.
PowerOn by PCI Card
When set at Enabled, any PCI-PM event awakes the system from a PCI-PM
controlled state. The options are Disabled, Enabled.
Modem Ring Resume
An input signal on the serial Ring Indicator (RI) line (in other words, an
incoming call on the modem) awakens the system from a soft off state.
The options are: Enabled, Disabled.
RTC Alarm Resume
Enabled allows you to set the time the system will be turned on from the
system power-off status. The options are: Enabled, Disabled.
Date (of Month)
This feature allows you to set the day of the alarm starts when the RTC
Alarm Resume From Soft Off is set to be Enabled. The options are: 0, 1..31.
BIOS Setup
3 - 17