Connect Atx Power - FIC K7M-400A Instruction Manual

K7M-400A Mainboard Manual
3. Place the fan with heatsink on the CPU top
and press down on the two plastic clips,
hooking them up with the holes on the two
sides of the retention module.
4. Press the white bar on each clip down to
fasten the fan set on the retention module.

Connect ATX Power

The 20-hole power plug (1st figure) is connected to the ATX power 20-pin
pinheaders. The 4-hole 12V power plug (2nd figure) is inserted in the ATX_12V
power connector.
2 - 6