FIC K7M-400A Instruction Manual page 53

Reset Configuration Data
Enabling this, resets the system Extended System Configuration Data
(ESCD) when you exit Setup, if you have installed a new add-on card and
the system reconfiguration has caused such a serious conflict that the
operating system can not boot. The options are: Disabled, Enabled.
Resources Controlled By
If set at Auto, the BIOS arranges all system resources. If there exists a
conflict, select Manual. The options are: Auto (ESCD), Manual.
If manual is chosen, after the feature IRQ Resources is pressed, the IRQ-
Assigned To are: PCI Device, Reserved. When resources are controlled
manually, assign each system interrupt a type, depending on which device
type uses the interrupt.
PCI/VGA Palette Snoop
Set this feature to be enabled if any ISA adapter card installed in the system
requires the VGA palette snoop function.
The options are: Disabled, Enabled.
Assign IRQ For VGA
If your PCI VGA card devices do not need an IRQ, select Disabled; there-
fore, an IRQ can be released for the system use.
The options are: Enabled, Disabled.
Assign IRQ For USB
If your USB devices do not need an IRQ, select Disabled; therefore, an IRQ
can be released for the system use.
The options are: Enabled, Disabled.
BIOS Setup
3 - 19