K7M-400A Mainboard Manual
2. Remove the corresponding slot cover from the computer chassis. Un-
screw the mounting screw that secures the slot cover and pull the slot cover
out from the computer chassis. Keep the slot cover mounting screw nearby.
3. Push the card firmly into the slot.
Push down on one end of the expan-
sion card, then the other. Use this rock-
ing motion until them card is firmly
seated inside the expansion slot. Se-
cure the card with the screw removed
in Step 2.
5). Connect Devices
Floppy Diskette Drive Connector
This connector provides the connection with your floppy disk drive.
Insert the floppy ribbon cable
(below) onto the floppy connector.
The colored stripe (indicated by the
arrow head, right) of the ribbon cable
must be the same side as Pin 1.
2 - 8