Ide Hdd Device Connectors: Primary And Secondary; Printer Block Connector: Printer - FIC PA-2006 Manual

PA-2006 Mainboard Manual
IDE HDD Device Connector: PRIMARY and SECONDARY
These two 40-pin block connectors are used for your IDE hard disks. It you
have one IDE hard disk, connect it to the PRIMARY connector using the IDE
HDD flat cable provided with the mainboard. The BIOS auto detection sets it to
be a "Primary Master" disk. If you want to install another IDE hard disk or
CD-ROM, please use the SECONDARY connector. If two hard disks are
connected to the PRIMARY connector using the same cable, one of them is the
master drive, the other one is the slave drive. You may need to set jumpers for
the slave drive; please refer to the HDD manual for details.

Printer Block Connector: PRINTER

This 26-pin male block connector is attached to your printer via a cable. When
inserting the cable, please be sure that the red line is always on the same side as
pin 1 of this connector.
44