Table of Contents
Advertisement
PA-2011 Mainboard Manual
IDE HDD Device Connectors: PRIMARY and SECONDARY
These two 40-pin block connectors are used for your IDE hard disks. It you have
one IDE hard disk, connect it to the PRIMARY connector using the IDE HDD
flat cable provided with the mainboard. The BIOS auto detection sets it to be a
" Primary Master" disk.
If you want to install another IDE hard disk or
CD-ROM, please use the SECONDARY connector. If two hard disks are
connected to the PRIMARY connector using the same cable, one of them is the
master drive, the other one is the slave drive. You may need to set jumpers for
the slave drive; please refer to the HDD manual for details.
Printer Connector: PRINTER
This 25-pin D-Sub female connector is attached to your printer.
40
Advertisement
Table of Contents
