Table of Contents
Advertisement
Installation Procedures
IDE HDD Device Connector: PRIMARY and SECONDARY
These two 2x20 pin male connectors are used for your IDE hard disks. If you
have one IDE hard disk, connect it to the PRIMARY connector using the IDE
HDD flat cable provided with the mainboard. The BIOS auto detection sets it to
be a Primary Master disk. If you want to install another IDE hard disk or
CD-ROM, please use the SECONDARY connector.
If two hard disks are
connected to the PRIMARY connector using the same cable, one of them is the
master drive, the other one is the slave drive. You may need to set jumpers for
the slave drive; please refer to the HDD manual for details.
Printer Connector: PRINTER
This 26-pin D-type female connector is attached to your printer via a cable.
37
Advertisement
Table of Contents
