Table of Contents
Advertisement
See the Safety section in this manual for more information. Avoid any horn use without an appropriate purpose.
Additional information regarding audible warning signals should be covered in a safe boating course.
Compass
The compass is located on the dash on top of the console. To ensure that the
compass light is working properly, press the Nav. lights switch in the forward
position to turn on the red LED light inside the compass. When finished, turn
the Nav. lights switch back to the middle position.
Please refer to the owner's manual provided by the manufacturer of the
compass for operational procedures and for information related to the care and
maintenance of their product. When in doubt, always defer to the compass
manufacturer's instructions and/or recommendations.
Full Instrumentation / Gauges (Digital)
All gauges are installed on the console but the configuration and specific location of your gauges will vary
depending upon the selection of the various optional engine packages. If your engine package includes analog
gauges (i.e., Faria), the gauges will light up when the navigation lights are on. If your engine package includes
digital gauges provided by the engine manufacturer (i.e., Mercury SmartCraft, Honda, etc.), the gauges will light
up only when the engine is on.
Note: For boats rigged with analog gauges (i.e., Faria), the gauge configuration may include
individual gauges for temperature, trim, volts and fuel gauges or a multifunction gauge that
includes these 4 gauge functions. For boats rigged with digital gauges, the temperature, trim,
volts and fuel gauges are incorporated into the tachometer gauge.
Tachometer - To ensure the tachometer (tach) is working properly, simply turn the ignition key on and start the
engine. While the engine is idling, the tach should be reading in the proper RPM range recommended for the
engine. Your engine manual will indicate the appropriate RPM range. When you are running at wide-open
throttle, the tach should read near the top end of the recommended RPM range.
If the RPM gauge is reading correctly and the engine throttle settings are correct, the tachometer is operating
properly. If the tachometer is not reading correctly, refer to the manual provided by the manufacturer of the gauge
(included in your owner's package).
Speedometer - To ensure that the speedometer (Speedo) is working properly, get the boat on a planing speed
and check to see if the gauge is reading at the approximate running speed at which the boat is traveling.
Note: The speed-reading on the Speedo may vary a few mph from the actual speed that the boat
is traveling. Either a GPS or a radar gun can check the running speed.
Trim - To ensure the trim gauges/indicators are working properly, start by making sure the engine is trimmed all
the way down. Locate the trim gauge on the instrument panel and check to see if the level on the trim gauge is in
the full down position. As you trim the engine up, watch the trim gauge and ensure that it coincides with the
actual trim of the engine. When finished trimming the engine all the way up, the level on the trim gauge should
read in the full up position.
Volts - To system check the volt gauge, turn the ignition key on and turn on the engine. With the engine running,
check the reading on the volt gauge. It should be reading between 12 and 14.5 volts. This reading ensures that
the charging system and the volt gauge are working properly.
Fuel - The fuel gauge reads the amount of fuel remaining in the tank. To check the fuel gauge, place a known
amount of fuel into the fuel fill and fill the tank. Turn the ignition key on and the fuel gauge should read the
approximate amount of fuel in the tank.
27
Advertisement
Table of Contents
