Table of Contents
Advertisement
Two push in switches for the spreader lights and courtesy light are located on the base of the courtesy
light.
To operate the courtesy light - Press the switch labeled courtesy once to turn on the
white courtesy light. When you press the same switch a 2
will be turned off and the red courtesy light (for night vision) will turn on. Press the same
rd
switch a 3
time to turn off the red courtesy light.
To operate the spreader lights - The spreader light switch operates in the same manor as
the courtesy light but only needs to be pressed in once to be turned on and once again to
be turned off.
Instrumentation
Compass
The compass on the 24 Walk is located on the dash on top of the
console. To ensure that the compass light is working properly,
press the Nav. lights switch in the forward position to turn on the
red LED light inside the compass. When finished, turn the Nav.
lights switch back to the middle/off position.
Please refer to the owner's manual provided by the manufacturer of the compass for operational
procedures and for information related to the care and maintenance of their product. When in doubt,
always defer to the compass manufacturer's instructions and/or recommendations.
Horn
The horn switch is located on the switch panel and the horn device is located on the starboard side of the
top cap, just aft of the bow pulpit.
Depress the horn switch to the up or forward position to activate the horn, then release the horn switch to
deactivate the horn. The horn is used to signal, warn or alert other boats or persons on shore. Using
different sequences of horn blasts indicates different and sometimes dangerous situations to you or
someone around you.
See the Safety section in this manual for more information. Avoid any horn use without an appropriate
purpose. Additional information regarding audible warning signals should be covered in a safe boating
course.
Full Instrumentation / Gauges (Digital Except Suzuki)
All gauges are installed on the console but the configuration and specific location of your gauges will vary
depending upon the selection of the various optional engine packages. If your engine package includes
analog gauges (i.e., Faria), the gauges will light up when the navigation lights are on. If your engine
package includes digital gauges provided by the engine manufacturer (i.e., Mercury SmartCraft, Honda,
etc.), the gauges will light up only when the engine is on.
Note: For boats rigged with analog gauges (i.e., Faria), the gauge configuration may
include individual gauges for temperature, trim, volts and fuel gauges or a multifunction
gauge that includes these 4 gauge functions. For boats rigged with digital gauges, the
temperature, trim, volts and fuel gauges are incorporated into the tachometer gauge.
nd
time, the white courtesy light
21
Advertisement
Table of Contents
