Courtesy Light - Cabin; Cockpit Lights; Navigation And Anchor Lights; Underwater Lights (Optional) - Pro-Line Boats 2010 29 Express Owner's Manual

Table of Contents

Advertisement

Switch the DC main and the cabin light switches to the on position to turn on the cabin lights. Each of these lights
can then be turned on or off individually. When you are finished using the lights, press the cabin light and DC
main switches to the off position.
Bullet lights (3) are located in the main cabin. Each light can be turned on individually by turning
the small switch located on the base of the light.
A florescent light is located in the head area and can be turned on by pressing the small switch
located at the end of the light assembly.
A dome light is located in the mid berth and can be turned on by flipping the small toggle switch
on the base of the light assembly.

Courtesy Light - Cabin

A small courtesy light is installed at the top of the cabin steps. This light can be
turned on at the console by pressing the courtesy light switch in the forward position.
The switches on the AC/DC panel do not control this light.

Cockpit Lights

The cockpit lights are small circular lights located around the forward and aft cockpit
area. Locate the 2-way cockpit light switch on the switch panel and press the switch
in the forward position to turn on the cockpit lights. Press the cockpit light switch in the
aft position to turn the lights off.

Navigation and Anchor Lights

The navigation and anchor lights are required to be used for operation at night or under low visibility conditions to
indicate your position to other boaters. Visually check the operation of your navigation and anchor lights and
verify that the lights are free from obstructions. You should check your navigation lights monthly during optimum
visibility conditions.
When you are underway in low visibility conditions, you should have the Nav. Lts. switch in the up
or forward position. This will activate the navigation lights, as well as your anchor light.
When you are anchored or in low visibility conditions, you should turn on the anchor light. Press
the Nav. Lts. switch to the down or aft position to turn on the anchor light.
The navigation lights consist of a pair of stainless steel lights that are mounted at the
bow of the boat. The red light is installed on the port side and the green light is
installed on the starboard side.
If you have selected the optional hard top, the anchor light will be mounted on the
center of the fiberglass top. If you have not selected the optional hard top, the anchor
light will be mounted on the windshield frame. This light must be secured in the up
position when you are underway.

Underwater Lights (Optional)

A pair of underwater lights can be installed on the hull just below the water line. The
lights have LED (light emitting diode) bulbs with a lifespan of approximately 20,000
hours. The lights give off a soft warm light that attracts baitfish, which in turn attracts
larger fish. They also provide a little ambiance for those romantic evenings.
A separate light switch panel is installed on the console. Just set the switch in the on
position to turn the lights on and set the switch in the off position to turn the lights off.
23

Advertisement

Table of Contents
loading

Table of Contents