Table of Contents
Advertisement
Spreader Lights and Courtesy Light (Optional)
The installation of the spreader lights and
the dome shaped courtesy light requires
the optional hard top. The spreader lights
are mounted to the aft side of the hard top
frame, along the top edge. The courtesy
light is mounted to the bottom of the hard
top electronics box.
Two push in switches for the spreader
lights and courtesy light are located on the
base of the courtesy light.
To operate the courtesy light - Press the switch labeled courtesy once to turn on the white
courtesy light. When you press the same switch a 2
off and the red courtesy light (for night vision) will turn on. Press the same switch a 3
turn off the red courtesy light.
To operate the spreader lights - The spreader light switch operates in the same manor as the
courtesy light but only needs to be pressed in once to be turned on and once again to be turned
off.
Remote Spot Light (Optional)
The installation of the remote
spot light requires the optional
hard top.
The remote spot
light is mounted to the forward
area of the fiberglass top. To
operate the remote spot light,
locate the remote spot light
panel that is installed on the
console.
The switch on the right side of the panel allows you to turn the light on and off. The red LED light located in the
center of the panel will be lit when the spot light is turned on. Once the spot light is turned on, the all around
toggle lever (on the left side of the panel) can be moved in an up, down, left or right position to rotate the light
assembly in the desired direction.
Air Conditioner with Heater (Optional)
The air conditioner unit is installed under the V berth in the
main salon of the cabin and comes equipped with 3 types of
vents that are located in the main salon, the mid berth and
the head. The air conditioner return is installed on the aft wall
of the center V berth storage area. The air conditioner runs
off shore power (standard equipment) or the generator
(optional equipment), not the battery.
The breaker switch for the air conditioner is located on the
AC/DC panel in the cabin. Turn the switch to the on position.
Then, turn on the blower switch, which is located next to the AC/DC panel. Once both switches have been set, go
to the air conditioner thermostat control panel. This panel is installed on the port wall of the cabin in close
proximity to the AC/DC panel.
Press the on/off button on the air conditioner thermostat panel once to activate the system. Press the fan button
to navigate between the various fan speeds. The up (warmer) and down (cooler) arrow buttons allow you to
control the temperature which is also displayed at the top of the air conditioner thermostat panel (refer to the
Spreader lights
nd
time, the white courtesy light will be turned
Remote spot light
Courtesy / Dome light
rd
time to
Remote spot light control panel
24
Advertisement
Table of Contents
