Cessna 1980 182Q Pilot's Operating Handbook And Flight Manual page 348

29
CESSNA 400 TRANSPONDER PILOT'S OPERATING HANDBOOK
AND ALTITUDE ENCODER (BLIND) SUPPLEMENT
SECTION 2
LIMITATIONS
There is no change to the airplane limitations when this avionic
equipment is installed. However, the following information must be
displayed in the form of a placard located near the altimeter.
ALTITUDE ENCODER .EQUIPPED
SECTION 3
EMERGENCY PROCEDURES
TO TRANSMIT AN EMERGENCY SIGNAL:
1. Function Switch -- ON.
2. Reply-Code Selector Switches -- SELECT 7700 operating code.
TO TRANSMIT A SIGNAL REPRESENTING LOSS OF ALL
COMMUNICATIONS (WHEN IN A CONTROLLED ENVIRONMENT):
1.
Function Switch -- ON.
2. Reply-Code Selector Switches -- SELECT 7700 operating code for 1
minute; then SELECT 7600 operating code for 15 minutes and then
REPEAT this procedure at same intervals for remainder of flight.
SECTION 4
NORMAL PROCEDURES
BEFORE TAKEOFF:
1. Function Switch -- SBY.
TO TRANSMIT MODE A (AIRCRAFT IDENTIFICATION) CODES IN
FLIGHT:
1.
Reply-Code Selector Switches .-- SELECT assigned code.
2. Function Switch -- ON.
4
1 October 1979