Cessna 1980 182Q Pilot's Operating Handbook And Flight Manual page 236

11
FOSTER AREA NAVIGATION
(TYPE 511)
PILOT'S OPERATING HANDBOOK
SUPPLEMENT
c. Excess RANGE to Waypoint (6) -- This would be any value
over 199 NM. (A check of aircraft position relative to the
VORTAC and Waypoint will detect and verify this condition.)
2. Missing DME Signal Display -- This will show as "00.0" in the
RANGE NM digital display (6) when the VOR/DME button (2) is
held in. The missing DME signal is then the reason for the FLAG
condition. (If valid VOR and DME data is displayed, then another
cause must be sought.)
3. Temporary Display of Unchanging Random Digits in the BEAR-
ING and RANGE Windows (2
&
6) at Time of Initial Turn-ON --
Such a condition is caused by a random interpretation of the micro
processor cycle. The RNA V 511 will Flag this malfunction by a
complete blanking of all display functions. The pilot can reset the
micro processor cycle by turning the RNA V OFF and then ON.
WAYPOINT PROGRAMMING
1. Using a VFR Sectional or other appropriate maps -- DETERMINE
distance and bearing for desired waypoint(s) from appropriate
VOR/DME stations.
2. VHF Navigation Receiver -- ON (When installed with DME 190,
RNA V 511 is connected to the Nav 1 Rcvr. When installed with the
400 DME, RNAV 511 may be connected to either the Nav 1 or Nav 2
Rcvr.) and channeled to the desired VORTAC.
3. DME ON/OFF Switch -- ON.
4. DME Remote Channeling Selector on DME 190 Selector -- SET to
REM position on DME 190.
5. DME Mode Selector on 400 DME -- SET TO desired NAV 1 or NA V 2
position on 400 DME.
NOTE
RNA V and HOLD positions on the 400 DME Mode Selector
are not used with this installation. RNA V is automatically
channeled to the selected Nav receiver.
6. GS/ TTS Selector Switch (on 400 DME) -- SET as desired. (Will only
display ground speed component or time-to-station at that speed to
the selected VOR --not the waypoint.)
7. RADIAL and DISTANCE Thumbwheels -- SET to first waypoint
RADIAL and DISTANCE. (Typically, the first waypoint is set into
the left side set of thumbwheels.)
8. RADIAL and DIST ANCE Thumbwheels -- SET to second waypoint
RADIAL and DISTANCE. (Typically, the second waypoint is set
into the ri.ght set of thumbwheels.)
9. Left WPT Pushbutton Switch -- PUSH in.
a. First waypomt RADIAL and DISTANCE are placed in unit as a
waypolnt.
6 1 October 1979