Cessna 1980 182Q Pilot's Operating Handbook And Flight Manual page 301

PILOT'S OPERATING HANDBOOK
SUPPLEMENT
22
CESSNA 400 ADF
(TYPE R-446A)
1.
PRI (pRIMARY FREQUENCY SELECTOR) - Selects and displays "primary"
frequency.
2. 1-2 - The "1" position activates "primary" (PRI) frequency. The "2" position
activates "secondary" (SEC) frequency.
3. SEC (S.ECONDARY FREQUENCY SELECTOR) - Selects and displays "secon-
dary" frequency.
4. SECONDARY RESELECT LAMP - Lamp will flash only when "secondary"
(SEC) frequency selection is outside of operating range of the receiver and 1-2
switch is in the "2" position.
5. TEST - Momentary-on switch used only with ADF function to test bearing
reliability. When held deptessed. slews indicator pointer; when released. if
bearing is realiable. pointer returns to original position.
6. BFO - Pushed
in:
Activates beat frequency oscillator tone to permit coded
identifier of stations transmitting keyed CW signals (Morse Code) to be heard.
7. REC - Pushed in: Selects receive mode (set operates as a standard communica-
tions receiver using sense antenna only).
NOTE
In this position an automatic pointer stow feature will alert the pilot
to non-ADF operation by positioning and retaining the pOinter at
the 3:00 o'clock position when the 400 ADF is in the REC function.
8. ADF - Pushed in: Selects ADF mode (set operates as automatic direction finder
using loop and sense antennas).
9. PRIMARY RESELECT LAMP - Lamp will flash only when "primary" (PRI)
frequency selection is outside of operating range of the receiver and 1-2 switch is
in the "1"" position.
10. OFF-VOL - Turns set on or off and adjusts receiver volume.
11. INDEX - Fixed reference line for dial rotation adjustment.
12. POINTER - When HDG control is adjusted. indicates either relative. magnetic. or
true bearings of a radio station.
13. HDG - Rotates dial to facilitate relative. magnetic. or true bearing information.
Figure 1. Cessna 400 ADF Operating Controls and Indicator
(Sheet 2 of 2)
1 October 1979
3