Cessna 1980 182Q Pilot's Operating Handbook And Flight Manual page 308

23
CESSNA 400 RNA V
(TYPE RN-478A)
PILOT'S OPERATING HANDBOOK
SUPPLEMENT
reason, intermittent RNA V signal loss may be expe-
rienced enroute. Prolonged loss of RNA V signal shall
require the pilot to revert to other navigational proce-
dures.
WAYPOINT PROGRAMMING:
1.
Using a VFR sectional, enroute instrument chart, instrument
approach plate, or enroute RNA V chart -- DETERMINE distance
and bearing for desired waypoint(s) from appropriate VOR/DME
stations.
2. VHF Navigation Receiver -- ON.
3. DME TEST/ON-OFF Switch -- ON.
4. DME Mode Selector Switch -- RNA V.
5. RNA V DSPL Switch --
1.
NOTE
When DSPL and FLY switches are not set to the same
waypoint number. the display/fly light slowly blinks on
and off as a reminder to the pilot that values displayed are
not those being used for navigation. This does not affect
operation of the unit.
6. BEARING Minilever Switches -- SET to first waypoint bearing.
7. DISTANCE Minilever Switches -- SET to first waypoint distance.
8. XFER Pushbutton Switch -- PUSH in.
a. First waypoint bearing and distance are placed in memory as
waypoint
1.
b. BEARING Display Readout -- DISPLAYS readout of first
waypoint bearing.
c. DISTANCE Display Readout -- DISPLAYS readout of first
waypoint distance.
9. RNA V DSPL Switch -- SET to 2.
10. BEARING Minilever Switches -- SET to second waypoint bearing.
11. DISTANCE Minilever Switches -- SET to second waypoint dis-
tance.
12. XFER Push button Switch -- PUSH in.
a. Second Waypoint Readout -- BEARING and DISTANCE are
placed in memory as waypoint 2.
b. BEARING Display Readout -- DISPLAYS readout of second
waypoint bearing.
c. DISTANCE Display Readout -- DISPLAYS readout of second
waypoint distance.
13. BEARING :Minilever Switches -- SET to standby waypoint bear-
ing.
4 1 October 1979