Cessna 1980 182Q Pilot's Operating Handbook And Flight Manual page 290

20
CESSNA 300 TRANSPONDER
AND ENCODING ALTIMETER
PILOT'S OPERATING HANDBOOK
SUPPLEMENT
SECTION 2
LIMITATIONS
There is no change to the airplane performance when this avionic
equipment is installed. However, the encoding altimeter used in this
installation does have a limitation that requires a standard barometric
altimeter to be installed as a back-up altimeter.
SECTION 3
EMERGENCY PROCEDURES
TO TRANSMIT AN EMERGENCY SIGNAL:
1.
Function Switch -- ON.
2. Reply-Code Selector Knobs -- SELECT 7700 operating code.
TO TRANSMIT A SIGNAL REPRESENTING LOSS OF ALL
. COMMUNICATIONS (WHEN INA CONTl'tOLLED ENVIRONMENT):
1.
Function Switch -- ON.
2. Reply-Code Selector Knobs -- SELECT 7700 operating code for 1
minute; then SELECT 7600 operating code for 15 minutes and then
REPEAT this procedure at same intervals for remainder of flight.
SECTION 4
NORMAL PROCEDURES
BEFORE TAKEOFF:
1.
Function Switch -- SBY.
TO TRANSMIT MODE A (AIRCRAFT IDENTIFICATION) CODES IN
FLIGHT: .
1.
Reply-Code Selector Knobs -- SELECT assigned code.
4
1 October 1979