Cessna 1980 182Q Pilot's Operating Handbook And Flight Manual page 226

9
DME
(TYPE 190)
PILOT'S OPERATING HANDBOOK
SUPPLEMENT
SECTION 3
EMERGENCY PROCEDURES
There is no change to the airplane emergency procedures when this
avionic equipment is installed.
SECTION 4
NORMAL PROCEDURES
TO OPERATE:
1.
Mode Selector Switch -- SELECT desired DME function.
2.
Frequency Selector Knobs -- SELECT desired frequency and allow
equipment to warm-up at least
2
minutes.
NOTE
If remote channeling selector is set in REM position, select
the desired frequency on the
#1
Nav radio.
3.
PUSH TEST Control -- PUSH and observe reading of
188.8
in
function window.
4.
DIM Control -- ADJUST.
5.
DME SPEAKER/PHONE Selector Switch (on audio control panel)
-- SELECT as desired.
6.
IDENT CONTROL -- ADJUST audio output in speaker or headset.
7.
Mode Selector Functions:
MILES Position -- Distance-to-Station is slant range in nauti-
cal miles.
MIN Position -- Time-to-Station when flying directly to sta-
tion.
KNOTS Position - -Ground Speed in knots when flying directly
to or from station.
CAUTION
After the DME 190 has been turned OFF, do not turn it on
agam for 5 seconds to allow the protective circuits to reset.
SECTION 5
PERFORMANCE
There is no change to the airplane performance when this avionic
equipment is Installed. However. the installation of an externally mounted
antenna or seyeral related external antennas. will result in a minor
reduction in cruise performance.
4
1 October 1979