Printer Status - Printronix T8000 Administrator's Manual
Hide thumbs
Also See for T8000:
- Administrator's manual (309 pages) ,
- Administrator's manual (338 pages)
Table of Contents
Advertisement
Table 5. ENQ/STX Status Byte
Bit
Printer Status
0
Set when the printer is not ONLINE or the buffer is full.
1
Set when the printer is OFFLINE.
2
Clear during a paper out fault.
3
Always set.
4
Set during a Head Open fault.
5
Set during a buffer overflow fault.
6
Set during a parity or framing error fault.
7
Always clear.
Table 6. ENQ Status Byte
Bit
0
Set when the label has printed.
1
Set when the label is presented.
2
Set while the printer is ONLINE.
3
Always set.
4
Set printing in the batch mode.
5
Set during a Ribbon fault.
6
Set during a Paper Out fault.
7
Set during a Head Open fault.
Host IO > Serial > Framing Errors
These are possible errors that can occur when serial interface settings of the
printer do not match those of the host computer. This menu determines
whether this error is shown on the control panel.
Disable
Feature disabled.
If a framing error occurs, a fault message will display
Enable
on the control panel.
Factory Default
Enable
Printer Status
181
Advertisement
Table of Contents
