Printronix T8000 Administrator's Manual page 289

PTX_SETUP commands have the following format:
(SFCC)PTX_SETUP
Command–Sub Command;Value
PTX_END
For example, if the SFCC assigned to PTX_SETUP is the default value of the exclamation mark (!, hex 21),
and you wanted to load configuration number 4 and capture all incoming data to a file named "BIN", you
would use the following command:
!PTX_SETUP
CONFIG–LOAD;4 FILE_IO–CAPTURE;BIN
PTX_END
Table 27 lists all the command, sub-command, and parameter combinations and gives a brief description
of the command. This section documents the existence of PTX_SETUP commands which work across all
platforms. The following sections document commands which are specific to thermal.
NOTE:
When a file system error occurs, a message will be displayed on the front panel indicating the
error, and the action needed to take to correct the error.
Command
CONFIG
Table 27. General PTX_SETUP Commands
Sub-Command
LOAD
SAVE
SETMENU
POWERUP
Parameter
Cfg Cfg can be 0-8. The PTX_SETUP
will load configuration Cfg. If
configuration Cfg was not previously
saved, the operator panel will
display an error message and the
current configuration will be kept.
Cfg Cfg must be 1-8. This command will
save the current configuration as
configuration Cfg. If Cfg is not in the
range of 1-8, the command is
ignored.
Value;Menu_tag Menu_tag is the name of the menu
as defined in the menu file. Value is
the value to which the menu is to be
set.
Cfg
Sets the power-up configuration to
Cfg and loads Configuration Cfg.
Cfg can be any value from 0-8,
where 0 is the factory default.
Description
289