Printronix T8000 Administrator's Manual page 251

Table 13. LCD Message Troubleshooting
Displayed Message
ERROR OCCURRED
FLUSHING QUEUES
FAN FAULT
FATAL ERROR
xxxx
FILE EXISTS
Enable Overwrite
FILE SYS FULL
Delete Files
FILE SYS FULL
Optimize&Reboot
FILE SYS INVALID
Optimize&Reboot
Solution/Explanation
An interim message displays while the printer discards host
data it cannot use because a fault condition exists. While
this message displays, the asterisk (*) rotates.
Wait. When the asterisk (*) stops rotating, a different fault
message will appear; troubleshoot the final message.
Contact your authorized customer service representative
The printer detected that the power supply fan did not
rotate.
1. Verify that the fan rotates when the printer is first
powered up and when the printer moves media or
prints.
2 C ll th i
A fatal software error has occurred.
1. Cycle Power. Run the print job again. If the message
appears, load the latest firmware.
2. Run the print job again. If the message appears, record
the display message and follow the instructions for
Diagnostics for Fatal Error: page 236.
3. Contact your authorized customer service
representative.
The printer operator tried to save a file using the name of
an existing stored file.
1. Enter the System > Flash File Edit menu and enable
the Overwrite Files feature to overwrite the existing file.
Insufficient flash memory available to store file. Given there
is 512MB of Flash Memory, this error is still possible but
unlikely.
1. Go to the System > Flash File Edit section of the menu.
2. Check the amount of flash memory that can be
optimized from the "Flash Reclaimable" menu.
3. If this value is small, then use "Delete Files" to delete
unwanted files.
4. If this value is large, then run "Optimize & Reboot".
File system not detected or flash was corrupted.
1. Run the System > Flash File Edit > Optimize & Reboot
feature.
The file system was given an invalid request.
1. Run the System > Flash File Edit > Optimize & Reboot
feature.
d i t ti
251