Media > Ribbon - Printronix T8000 Administrator's Manual

Media > Ribbon
Sets the ribbon operating parameters automatically based on the label
settings or manually if the media width is less than the ribbon width.
Same as Paper
Set in Menu
Factory Default
When the menu Ribbon Width is set to "Set in Menu", this menu is unhidden
and can be used to set the proper Ribbon Width value.
Minimum
Maximum
Factory Default
When enabled and the amount of ribbon remaining on the supply spindle is
approximately 75 to 50 meters or less, a "Ribbon Low" warning will pop up on
the ONLINE screen.
Disable
Enable
Factory Default
This controls a fault message for a Ribbon Takeup Full condition.
Disable
Enable
Factory Default
Media > Ribbon > Ribbon Width
The printer automatically adjusts the ribbon operating
parameters to match the installed media width.
In those cases where the media width is less than the
installed ribbon width, this option should be selected.
After selection, the menu "Ribbon Width Adj" is
unhidden and is used to determine the ribbon width.
Same as Paper
Media > Ribbon > Ribbon Width Adj
0.1 inches
Maximum based on printer model/printhead.
0.1 inches
Media > Ribbon > Ribbon Low
No Ribbon Low warning will appear.
The Ribbon Low warning will appear when the ribbon
on the supply spindle is 75 meters or less.
Disable
Media > Ribbon > Takeup Full
No fault message.
A fault message will occur for a Ribbon Takeup Full
condition.
Enable
71