Printronix T8000 Administrator's Manual page 73

Media > Top of Form > Ticket Save Mode
This option determines the action of the media for Continuous (Standard),
Tear-Off, Tear-Off Strip and Cut Media Handling Modes after the printer is
first powered up or after the printhead has been opened and then closed.
When enabled, this option eliminates wasting label(s) or ticket stock when the
printer advances media to search for the next TOF position.
Option applies only to 0.5 inch or longer label lengths.
The printer assumes that the media is not at the correct TOF
position after cycling power or after the printhead is opened
and then closed. Printing will begin only after the next TOF is
detected.
Disable
When disabling, Sensors > Calibrate > Online Action
and Sensors > Calibrate > HeadClose Action will not
be adjusted.
The printer will assume that media is at the TOF position
after cycling power or after the printhead is opened and then
closed. Printing will begin without advancing media to search
for the next TOF position.
Enable
When enabled, Sensors > Calibrate > Online Action
and Sensors > Calibrate > HeadClose Action will
automatically be set to Disable.
The printer will assume that media is not at the TOF position
after cycling power but is at the TOF position after the
printhead is opened and then closed. After powering up,
printing will begin only after the next TOF is detected. After
opening the head, printing will begin without advancing
No Seek
media to search for the next TOF position.
When enabled, Sensors > Calibrate > Online Action
and Sensors > Calibrate > HeadClose Action will
automatically be set to Disable.
Factory Default Disable
The user must ensure that media is at the correct
TOF position (cross perforation, liner gap, notch
or mark at the tear bar edge) before cycling power
or before closing and locking the pivoting deck. In
IMPORTANT
addition, media must be calibrated and the correct
Media Handling Mode, Label Length and Gap/Mark
Sensor selected and saved as the Power-Up
Config.
73