Printronix T8000 Administrator's Manual page 62

This option represents the distance to advance (+ shift) or pull back (– shift)
the stop position of a label when Tear-Off Strip, Tear-Off, Peel-Off, or Cut
Media Handling option is enabled. Allows .01 inch increments.
Minimum
Maximum
Factory Default
This option specifies the user-selected Label Length. In most applications,
the user-selected Label Length will match the physical label length. Physical
label length is the actual label length of the media installed:
Die-cut Labels: Measurable length of the removable label (leading edge to
trailing edge). This does not include the liner material or gap.
Tag Stock with notches or holes: Measurable length from the trailing edge of
one notch or hole to the leading edge of the next notch or hole.
Tag Stock with black marks on underside: Measurable length from the
leading edge of one black mark to the leading edge of the next black mark.
Continuous media (no label length indicators): Measurable length should be
within ± 1-2% the Label Length value here or the value sent via host software
command.
Minimum
Maximum
Factory Default
IMPORTANT
62
Media > Image > Paper Feed Shift
-1.00 inches
Current Label Length (or 12.80 inches maximum)
0.00 inches
Media > Image > Label Length
0.1 inches
99.0 inches
T8x04: 6.0 inches
T8x06: 4.0 inches
T8x08: 6.0 inches
This menu can be overridden by the host job (Host
Form Length) and set to values that do not match
the physical length. For a full description of how
Label Length behaves, see the section Intro: Label
Length.