Application > P-Series Setup - Printronix T8000 Administrator's Manual

Defined in linespaces, starting from line zero at the bottom of the page and
incrementing from the bottom up.
Minimum
Maximum
Factory Default
Selecting this executable menu by pressing the
printer to print the currently selected character set.
When the printer receives a host data stream reset command (ESC @ or
ESC[K) in addition to resetting printer variables, the selected configuration is
loaded.
Disable
Power-Up
Config
Current Config
Factory Config
Factory Default
Application > P-SERIES Setup
IMPORTANT
The P-SERIES Setup submenu will only be present when the LP+ Emulation
menu is set to P-SERIES. Otherwise, this menu will be replaced with the LP+
Emulation menu.
This option selects the Character Set Group. Based on the group selected,
then the character set can be chosen with the menu following XXX Sets. The
group Standard Sets is shown below because it is unique to P-Series. All
other groups are similar and described in LP+, PGL, VGL Character Sets.
144
Application > LP+ Setup > Bottom Margin
0 linespaces
451 linespaces
0 linespaces
Application > LP+ Setup > Print Char. Set
Application > LP+ Setup > Reset Cmd CFG Ld
The active emulation parameters are loaded when the
reset command is executed.
The power-up configuration is loaded when the reset
command is executed.
The currently selected configuration is loaded when
the reset command is executed.
The factory installed configuration is loaded when the
reset command is executed.
Disable
Application > P-Series Setup > Character Group
↵
ENTER key causes the