Printronix T8000 Administrator's Manual page 134

This option is for compatibility with mode switches for Code 128 barcodes.
Disable
Enable
Factory Default
This menu makes the old method of decoding C39 alternative character set
compatible with the new.
Disable
Enable
Factory Default
This menu is used for character filtering in the application stream.
Disable
Char 1
Char 2
Char 1&2
Factory Default
Specifies character 1 for the character filtering option. Valid decimal values
are from 0 through 255.
Minimum
Maximum
Factory Default
134
Application > VGL Setup > C128 Mode Comp.
Uses the normal auto switch for optimum barcodes.
Matches the older firmware auto switch algorithm.
Disable
Application > VGL Setup > C39 Compatbl.
Uses the better and more flexible way of decoding.
Matches the old method of decoding.
Disable
Application > VGL Setup > Ignore Chars
Uses the better and more flexible way of decoding.
Character 1 will be filtered. Select the VGL menu
option "Ignore Ch#1" to specify character 1.
Character 2 will be filtered. Select the VGL menu
option "Ignore Ch#2" to specify character 2.
Character 1 and 2 will be filtered. Select the VGL menu
options "Ignore Ch#1" and "Ignore Ch#2" to specify
character values to be ignored.
Disable
Application > VGL Setup > Ignore Ch#1
0
255
0