Use Of Remote Control; Virtual Wall; Battery Placement - ECOVACS Deebot D58 User Manual

Use of Remote Control

spot edge auto
return intensive
direction
control key

10.Virtual Wall

Battery Placement

18
You can control the robot via remote control.
Drive robot to appointed area via using direction control
button.
Choose certain working mode according to different
Automatic Cleaning Mode/
Cleaning Mode/
Pause key: temporarily stop current operating and make it stay where it is.
Direction control key: There are four direction control, ahead, backward,
left hand and right hand. You can use remote control to drive robot to any
appointed area.
You can control cleaning mode, going back charging and direction within five
meters through the function key on it.
If the robot is under cleaning mode or going back charging, please press
pause first and then can proceed direction control.
During the direction control, robot is not able to operate cleaning.
Make sure the power supply of remote control is on before you use it. When
you use it, match the signal transmitter with signal receiver on the host.
If robot is near charger, virtual wall or other infrared transmitter, it would be
interfered by infrared and fails to receive the signal of remote control, under
this situation, please manually operate the mode on the host.
Tips:
It applies two units of alkaline batteries (1#).
Please note the positive and negative when place the battery.
Change the battery when you notice it is in low battery and make sure
you use the same kind of battery as mixture is forbidden.
Take out the battery if you do not use remote control for long time to
avoid electrolyte from leaking which may cause failure.
Do not put the remote control in extremely hot or humid surroundings.
Do not fill any other substance into remote control, especially when
you change battery.
Never expose the signal transmitter under sunshine or lighting
equipment, or else it would cause failure.
The deposal of used battery should conform with local environmental
legislation.
Border Cleaning Mode/
Intensive cleaning mode
Fixed Point
/
Go Back Charging Mode