Virtual Wall; Battery Placement - ECOVACS ECO D77 Instruction Manual

11. VIRTUAL wALL

Battery Placement

Note
►When you use virtual wall, please face marked ECOVACS to the block area you expect.
►Put virtual wall outside of the room you want to block to get best effect.
►The virtual wall would turn off by itself automatically two hours later to save the battery. So
every time the robot start new task , please do check whether the indicator lights.
►If you have paused the host for long time during its operation, please examine frequently that
if the switch is off to prevent from danger.
Power: Press this key and virtual wall starts work which will prevent robot from entering the
blocked region.
Indicator: It is red when the power is on, and it shows virtual wall is ejecting invisible beam to
prevent robot form entering
the blocked region.
Infrared transmitter: Ejecting invisible beam.
Infrared receiver: Receive invisible beam.
P28 Infrared receiver
P29 Power
P30 Indicator
P31 Transmitter
ENG - 136
Tips:
• It applies two units of alkaline batteries R20.
• Please note the positive and negative when place the battery
• Change the battery when you notice it is in low battery
and make sure you use the same kind of battery as mixture is
forbidden.
• Take out the battery if you do not use virtual wall for long time
to avoid electrolyte from leaking which may cause failure.
• Do not put the remote control in extremely hot or humid
surroundings.
• Never expose the signal transmitter under sunshine or lighting
equipment, or else it would cause failure.
• The deposal of used battery should conform with local
environmental legislation.