Bow Pulpit W/Anchor Roller And Rope Locker Storage - Pro-Line Boats 2008 26 XP Pilot Owner's Manual

Bow Pulpit w/Anchor Roller and Rope Locker Storage

We have installed an aluminum anchor roller at the bow pulpit. The anchor line can be secured inside the
anchor locker and then routed through the anchor roller and/or windlass. The anchor (not included as
standard equipment) is held on the line beneath the anchor roller. This allows you to move about the bow
area safely without tripping over the line or anchor.
Dive Platform - Integrated w/Ladder
An integrated Euro style dive platform is built into the fiberglass construction of the deck and hull and
includes a stainless steel ladder on the port side of the transom.
An optional dive ladder (single engine installations only) can be installed on the starboard side of the dive
platform to allow additional boarding capability.
installation of an additional grab rail on the transom. With the engines tilted down, passengers can move
easily through the transom door and across the large dive platform to the optional ladder.
Storage
Your boat has storage areas for your tackle and/or gear:
•
Wet/dry storage compartments below the cabin V-berth
•
Tackle Box - Installed behind the hatch located below the transom door. It contains 3
trays for storing your small tackle.
•
Fire Extinguisher Holder - Installed in the port side cockpit. It is located within easy reach
of the helm seat.
•
Storage shelf behind the bolster cushion installed around the cabin.
•
Mesh storage pocket on the aft cabin wall.
•
Storage compartment beneath the optional leaning posts.
Rod Holder Storage: The following rod holder storage is available:
•
Rod Holders w/Inserts – Two pairs of stainless steel rod holders with PVC inserts to
protect your rods are installed on the gunwales.
•
Rod Racks - A pair of rod racks is installed in the port and starboard freeboard of the aft
cockpit. Combined, they can accommodate up to 8 fishing rods.
•
Four aluminum rocket launchers are installed on the aft edge of the fiberglass top that
encloses the pilothouse.
Hard Top
The molded fiberglass top that encloses the pilothouse is installed on top of the wrap around windshield.
A set of 4 rod holders is mounted to the aft legs of the frame; providing you with additional rod holder
capacity. Two small hatches are installed on the fiberglass top to allow for additional air circulation at the
helm station.
See the Service and Care section of this manual for cleaning recommendations for the anodized
aluminum frame and fiberglass hard top.
Note: Pro-Line DOES NOT offer outriggers on this model. When outriggers are factory
installed on some of our other models, we install mounting pads to the frame for
additional support. Before considering adding after market outriggers, we recommend
that you consult your Pro-Line dealer's Service Department or another qualified service
professional to add mounting pads to the top frame.
When factory installed, this option includes the
37