Hatches And Latches - Pro-Line Boats 2008 26 XP Pilot Owner's Manual

Cabin Hatches - A cabin hatch complete with screen is installed
in the ceiling of the main cabin. To open the window, remove the
screen, turn both levers forward and push the hatch open to the
desired position. To hold the hatch in place, tighten the black
plastic cylinders on both of the mounting arms. Then replace the
screen. DO NOT allow passengers to sit or stand on the hatch as
they could break the hatch. The hatch should be in the closed
and latched position when the vessel is underway.
Two smaller but similar hatches are installed in the fiberglass
There is a black plastic cylinder on
hard top for added air circulation in helm area.
each mounting arm.
Cabin Portholes - Two portholes complete with screens are
installed in the main cabin. One is located in the galley and
the other is located in the head. To open the porthole window,
loosen the 3 star nuts by turning them in a counter clockwise
direction. Then, rotate each of the star nuts down/away from
the plastic window; the window is hinged at the top. Once the
star nuts are out of the way, lift the window open and away
from the frame by pulling on the phalanges at the bottom of
the window.
When finished, close the window, rotate each of the star nuts
3 Star Nuts
back into place and turn the star nuts in a clockwise direction
to secure the window.

Hatches and Latches

Fiberglass Deck Hatches - The fiberglass deck hatches are strong, durable and can easily withstand the
weight of passengers and gear; just like the rest of the deck surfaces.
The twist latches that are installed on the fiberglass deck hatches are made of stainless steel. Just lift the
handle of the latch from the recessed area of the hatch, twist it and lift the hatch open. When you close
the hatch, make sure that the latch is secure.
Always ensure that all hatches are closed and secured before you get underway. If the latch does not
catch when the hatch is closed, lift the handle of the latch and turn it 180 degrees so that the latch
catches. Then, return the handle to the recessed area of the hatch.
In addition to the fiberglass deck hatches, there are additional round hatches on the boat that provide
access to many components. The following photo identifies the locations of the components that can be
accessed via the hatches.
33