Recovering From Loss Of Extrusion - µ-Dimension BST 1200es User Manual

Recovering from loss of extrusion

Note:
before performing any of the work.
1. Enter Head Maintenance mode.
a. From Idle, press Maintenance.
b. Press Machine.
c. Press Head. The head will heat up to operating temperature which will take
approximately 3 minutes.
Gloves:
printer.
2. Remove the head cover by pressing the tabs in and pulling away from the head. See
Figure 47: Remove the head cover
Head Cover
3. Place the toggle bar in neutral position (bar will extend equally from both sides of head). This
can be done manually - push on the extended bar end. See
It is recommended that you read and understand this entire procedure
The head area is hot. Use leather gloves when working in this area of
Press tabs in to remove
head cover
Figure 48.
56
Figure 47.