13. If material did not extrude from both tips follow the procedure in
the following section,
Recovering From Loss of Extrusion
It is recommended that you read and understand this entire
procedure before performing any of the work.
1. Enter Head Maintenance mode.
•
From Idle, press Maintenance > then Next > then
Head Maintenance.
2. Remove plastic head cover.
•
Remove plastic head cover by squeezing raised pads on
sides of cover.
3. Place the tip toggle bar in neutral position (bar will extend
equally from both sides of head -
manually - push on the extended bar end.
Figure 27: Tip Toggle Bar in Neutral Position
"Recovering From Loss of
NOTE
WARNING
The head area is very hot!! Use leather
gloves when working in this area of
printer!
Toggle Bar extends equally
from both sides of head.
Dimension BST 1200es / SST 1200es User Guide
Troubleshooting 65
Figure
27). This can be done
Extrusion".
Liquefier
Tubes