Table of Contents
Advertisement
Liquefier Tip Replacement
Replace Tips at approximately 2000 hours - depending upon operating conditions. Tips can also
be damaged by improper care while performing maintenance in the area around the tips.
Note:
Printer Info button (Tip time will reset to zero after replacement).
Removing Tips:
1.
You will need to make sure the printer is powered ON before replacing the extrusion tips.
2.
From the display panel press Maintenance.
3.
Press Machine.
4.
Press Tip.
5.
Press Replace.
6.
The printer will display Material Unload - Unloading Model.
7.
When finished unloading, the display will prompt to remove the material cartridges. Push the
material cartridges in and release to unlatch.
8.
You can now open the printer door and replace the tips - or you can Cancel the tip
replacement procedure.
9.
Remove plastic head cover by squeezing raised pads on sides of cover. See
Figure 36:
Removing the Head Cover
Head cover
10.
Remove Tips:
Use 7
a.
turns counterclockwise - or until the top of the screws are flush with the metal cover. DO
NOT remove the screws entirely. See
CatalystEX displays the tip time (hrs) - from the Printer Services Tab -
⁄
"
T-Handle Allen wrench to loosen the heater block screws three to four full
64
Press tabs in to remove
head cover
Figure 37
44
Figure 36
Hide quick links:
Advertisement
Table of Contents
