Setup; Unpacking - µ-Dimension BST 1200es User Manual

3

Setup

Unpacking

This section describes the recommended procedures for unpacking and preparing the printer for
its first use.
Unpack the printer:
WARNING:
and lifting techniques when positioning the unit. For your convenience, there are forklift
pads built into the bottom of the unit. They are accessible from the side of the unit.
1. Before unpacking the printer, move it near to its operating location.
2. Remove the plastic banding from around the cardboard.
3. Remove the top cover. Set aside the fork access covers (2) and bag of screws (2).
4. Remove screws (4) that attach cardboard to pallet and remove the cardboard side panels.
5. Remove the top foam.
6. Remove outer plastic wrap - use care if using a knife so as to not scratch the printer.
7. Remove the foam door channels (2) and tape.
WARNING:
grease. Krytox grease can cause skin irritation. Be careful not to get the grease on your
hands or clothing.
CAUTION:
Figure 6.
CAUTION:
see
8. Remove the foam tubes that isolate the extrusion head from the frame, see
The printer weighs approximately 148 kg (326 lbs). Use proper moving
The Lead Screw and Guide Rods are lubricated with a thin coat of Krytox
Remove the foam tubes that isolate the extrusion head from the frame, see
The printer will be damaged if powered on with the foam tubes in place.
Be careful not to damage the rod sensors when removing the foam tubes,
Figure 6.
9
Figure 6.