Insert Modeling Base - µ-Dimension BST 1200es User Manual

Insert Modeling Base

Make sure retainers are turned 'down' - so as not to interfere with the modeling base installation.
Set the modeling base on the Z Stage Platen aligning the tabs on the modeling base with the slots
on the metal tray. Slide the modeling base toward the back of the unit until its front edge (with the
handle) is flush with the front edge of the tray, see
retainers by turning them up.
Note:
avoid touching the top surface. Grease and oil that contact the top build
surface could cause poor part adhesion. You can clean the build surface with
isopropyl alcohol if necessary.
Figure 14 Inserting a modeling base
When inserting and removing the modeling base, use the handle to
Retainers
Figure 14. Secure the base with the two
Slide modeling base into
the side tray guides.
20