Table of Contents
Advertisement
2.
Turn the power switch to the on (I) position. See
system boots up in three to seven minutes.
Note:
minutes to warm up before you can perform any functions. Temperatures are factory-
preset and not adjustable. The panel displays the head and envelope temperatures
while the system is warming up and cooling down.
Note:
open. During warm-up and operation the door is locked. The door can be opened
only when the system is not building a part, getting ready to build a part, or in Pause
mode.
Figure 13
Location of power switch
Installing software
There are two software programs that work with the printer:
1.
CatalystEX, installed on your workstation, processes the STL files for printing and communicates
with the printer from your workstation.
2.
System software, the operating software installed on the printer, controls printer functions.
Installing CatalystEX:
1.
Locate the CatalystEX CD from startup kit and insert into workstation (PC).
2.
Click the Install CatalystEX: button.
3.
Follow prompts to finish loading CatalystEX on the workstation.
If the printer was off and is at room temperature, it requires approximately 40
For safety, the head and Z Platform do not move while the chamber door is
Figure 13.
After the switch is pushed, the
15
Hide quick links:
Advertisement
Table of Contents
