Nxa-Cftp Compact Flash (Fg2116-2X); Nxa-Pci80211G Wireless Card (Fg2255-04) - AMX NXD-1200V Operation/Reference Manual

NXA-CFTP Compact Flash (FG2116-2x)

Every Modero panel is shipped with two factory default modules: an EXM Memory Module and a Compact Flash card.
These panels are shipped with a 256 memory module which is not upgradeable.
The default 128 MB Compact Flash card is factory programmed with specific panel firmware and is the only
upgradeable memory component. This component can be ordered from AMX in several different upgrade sizes (as listed
in the following table):
Optional Compact Flash Memory Upgrades
Compact Flash:
NXA-CFTP256M - 256 MB Compact Flash card
NXA-CFTP512M - 512 MB Compact Flash card
NXA-CFTP1G - 1 GB Compact Flash card
Upgrading the internal components involves opening the panel enclosure/outer housing to access the internal circuit
board, removing the existing part, and replacing them with the upgrade components, as described in the following
sections.
It is recommended that any upgrade of internal equipment be done simultaneously in
order to reduce the risk of damage to internal components.

NXA-PCI80211G Wireless Card (FG2255-04)

The 1200V-Series and VG-Series Modero touch panels can connect to an internal NXA-PCI80211G compatible mini-
PCI Wireless Card connected to two antennas (57-2250-10). All 1200-V and VG-Series panels come factory installed
only with the two antennas used for later connection to the optional wireless card which is field-installable.
FIG. 15 NXA-PCI80211G mini-PCI Wireless Card
The NXA-PCI80211G card functions using a 2.4GHz bandwidth with a maximum data transfer rate of 54Mbps. This
card is compatible with IEEE 802.11 standards such as: 802.11b and 802.11g.
The NXA-80211G allows the end-user to take advantage of larger bandwidth to utilize features such as: wireless
intercom, Motion JPEG, networked video, and standard wireless Ethernet communication to both a NetLinx controller
and networked computers. Please follow your particular Wireless Access Point's instruction manual for the correct
procedures to setup either a secured or unsecured connection.
FCC Statement:
This device complies with Part 15 of the FCC rules. Subject to the following two conditions:
1. This device must not cause harmful interference and
2. This device must accept all interference, including interference that interferes with the
operation of this device.
Modifications not expressly approved by the manufacturer will void the user's authority
to operate the equipment.
WARNING: This device has been evaluated and found to be compliant with the FCC Rules
for RF Exposure when the device is operated at a minimum separation distance from the
user and nearby persons. Operation of this device at closer distances should be avoided.
Certifications: FCCID: CWU-WN2301A, CE, EN 60950, EN 300 328,
FIG. 16
NXD/T-1200V Wall/Flush Mount Touch Panel
and RSS 210
(FG2116-23)
(FG2116-24)
(FG2116-25)
Touch Panel Accessories
13