Removing The Rear Wheel - PIAGGIO Beverly Tourer 250 i.e. Service Station Manual

Suspensions
Soap-based lithium and zinc oxide grease con-
taining NLGI 2; ISO-L-XBCIB2
Rear

Removing the rear wheel

- Remove the muffler support bracket
- Remove the 5 screws shown in the photograph
Refitting the rear wheel
- Carry out the removal operations but in reverse order, observing the prescribed tightening torques.
Locking torques (N*m)
Fixing screw for wheel rim to hub 34 ÷ 38
Swing-arm
Removal
- Place the scooter on its centre stand;
- Support the engine adequately;
- Loosen the nut shown in the figure and pull out
the spindle from the left-hand side.
SUSP - 218
Beverly Tourer 250 i.e.