PIAGGIO Beverly Tourer 250 i.e. Service Station Manual page 234
Hide thumbs
Also See for Beverly Tourer 250 i.e.:
- User manual (84 pages) ,
- Service station manual (308 pages) ,
- Owner's manual (92 pages)
Table of Contents
Advertisement
Braking system
See also
Front
brake calliper
Refitting
To fit, proceed as follows:
- Insert the two pads in the callipers.
- Screw the two pad lock pins to the correct torque, and apply the recommended product.
- Fit the calliper on its support, tightening the two screws to the prescribed torque.
N.B.
IF IT IS NOT POSSIBLE TO CORRECTLY POSITION THE CALLIPER ON THE DISC DURING FIT-
TING, GENTLY EXPAND THE PADS.
Recommended products
Loctite 243 Medium strength threadlock
Loctite 243 medium-strength threadlock
Locking torques (N*m)
Pad fastening pin 19.6 ÷ 24.5
Rear brake pads
Removal
- Remove the rear brake calliper
- Loosen the two pins shown in the figure that lock
the two pads; be careful with the pad spring clamp.
- Remove the brake pad and check there are no
faults or warping. Replace it if such anomalies are
present.
- Check the thickness of the friction material is
more than 1.5 mm. If it is not , replace it
BRAK SYS - 234
Beverly Tourer 250 i.e.
Hide quick links:
Advertisement
Table of Contents
