PIAGGIO Beverly Tourer 250 i.e. Service Station Manual page 250

Chassis
- Remove the central frame cover, then unscrew
the 2 screws indicated in the figure.
- Remove the Piaggio symbol from the shield, then
remove the screw.
- Remove the legshield to the front.
- To reassemble, follows the steps in reverse or-
der, paying attention to the correct seating of the
shield on the shield back plate.
See also
Headlight assy.
Frame central cover
Knee-guard
- Remove the legshield; - Remove the 2 fixing
screws of the fuse box in the front glove box; -
Separate the electrical connections; - Remove the
expansion tank; - Remove the retaining screw in-
side the glove box; - Disconnect the saddle closing
mechanism; - Remove the rear shield with the
glove box.
CHAS - 250
Beverly Tourer 250 i.e.