PIAGGIO Beverly Tourer 250 i.e. Service Station Manual page 146

Engine
Crankcase - crankshaft - connecting rod
Refitting the crankcase halves
- Fit the internal bulkhead by locking the two
screws to the prescribed torque.
- Fit the oil filter fitting and tighten it to the specified
torque.
- Position the oil pre-filter element as shown in the
photograph.
- Place a new gasket on one of the crankcase
halves, preferably on the transmission side, to-
gether with the locating dowels.
- Lubricate the main bushings and insert the crank-
shaft in the transmission side crankcase half.
- Reassemble the two crankcase halves.
- Fit the 10 screws and tighten them to the pre-
scribed torque.
- Fit a new O-ring on the pre-filter and lubricate it.
- Insert the filter on the engine with the relative cap.
Tighten to the prescribed torque.
Locking torques (N*m)
Internal engine crankcase bulkhead (transmis-
sion-side half shaft) screws
case coupling screws
crankcase fitting
27 ÷ 33
plug/mesh filter
24 ÷ 30
ENG - 146
Engine-crank-
4 ÷ 6
Oil filter on
11 ÷ 13
Engine oil drainage
Beverly Tourer 250 i.e.