PIAGGIO Beverly Tourer 250 i.e. Service Station Manual page 211

Beverly Tourer 250 i.e.
Removal
- Remove the front wheel.
- Remove the front mudguard
- Remove the front brake calliper
- Remove the front and rear handlebar covers.
- Remove the pin mounting the handlebar to the
steering tube.
- Remove the handlebar and rest it on the shield
back plate.
- Remove by releasing the cable passages and
sliding the protection collar upwards.
Using the special tool, loosen and remove the up-
per ring nut, the spacer washer and the counter-
ring nut.
- Extract the fork.
N.B.
TAKE CARE TO SUPPORT THE FORK SO AS TO PREVENT
IT FROM COMING OFF ABRUPTLY
Specific tooling
020055Y Wrench for steering tube ring nut
Refitting
- Fit the lower steering fifth wheel on the steering
tube.
- Fit the fork together with the lower steering fifth
wheel on the headstock and hold it so that it does
not fall.
N.B.
LUBRICATE THE STEERING FIFTH WHEEL TRACKS WITH
RECOMMENDED GREASE BEFORE USE.
Recommended products
AGIP GREASE PV2 Grease for steering bear-
ings, bolt seatings for swinging arms and fay-
Suspensions
SUSP - 211