PIAGGIO Beverly Tourer 250 i.e. Service Station Manual page 181

Beverly Tourer 250 i.e.
Injection
Install the appropriate tool for checking fuel pres-
sure and position the manifold over a container
graduated by at least 100 cm³. Connect the injec-
tor with the cable making up part of the supply for
the injection tester. Connect the clamps of the ca-
ble to an auxiliary battery. Activate the fuel pump
with the active diagnosis. Check that, within fifteen
seconds, approximately 40 cm³ of fuel is dis-
pensed with an adjustment pressure of approxi-
mately 2.5 BAR.
Specific tooling
020480Y Petrol pressure check set
Proceed with the injector seal test.
Dry the injector outlet with a blast of compressed
air. Activate the fuel pump. Wait for one minute,
making sure there are no leaks coming from the
injector. Slight oozing is normal.
Value limit = 1 drop per minute
INJEC - 181