Removing The Piston - PIAGGIO Beverly Tourer 250 i.e. Service Station Manual

Engine
Inspecting the piston rings
Sealing rings
- Alternately insert the three sealing rings into the
cylinder, in the area where it retains its original di-
ameter. Using the piston, insert the rings perpen-
dicularly to the cylinder axis.
- Measure the opening (see figure) of the sealing
rings using a feeler gauge.
- If any measurements are greater than specified,
replace the piston rings.
N.B.
BEFORE REPLACING ONLY THE PISTON RINGS, ENSURE
THAT THE CLEARANCE BETWEEN THE PISTON RINGS
AND THE PISTON RING GROOVES, AND BETWEEN THE
PISTON AND THE CYLINDER, IS AS SPECIFIED. IN ANY
CASE, NEW PISTON RINGS USED IN COMBINATION WITH
A USED CYLINDER MAY HAVE DIFFERENT BEDDING
CONDITIONS THAN THE STANDARD.
Characteristic
Top piston ring
Standard opening: 0.15 ÷ 0.30 mm
Middle piston ring
Standard opening: 0.20 ÷ 0.40 mm
scraper ring
Standard opening: 0.20 ÷ 0.40 mm

Removing the piston

- Install piston and wrist pin onto the connecting
rod, aligning the piston arrow the arrow facing to-
wards the exhaust.
- Fit the wrist pin snap ring onto the appropriate
tool
- With opening in the position indicated on the tool
S = left
D= right
- Place the wrist pin stop ring into position using a
punch
- Fit the wrist pin snap ring using the plug as shown
in the figure
ENG - 128
Beverly Tourer 250 i.e.