Others - Epson SC-F7100 Series User Manual

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
c
Important:
If the printer is left off for an extended period,
the print head will be left uncapped and dry
out, and will not print properly when printing
resumes.
Turning the printer on automatically caps the
print head.
Reload the media and resume printing.
"Loading Media (SC-F7200/SC-F7100 Series)" on
U
page 30
"Loading Media (SC-F7000 Series)" on page 37
U
Media is not fed straight or taken up
well (SC-F7200/SC-F7100 Series)
Has parallel adjustment been performed for
o
the Media Feeding Unit and Auto Take-up
Reel Unit?
Perform parallel adjustment for the Media Feeding
Unit and Auto Take-up Reel Unit when there are
problems with media feeding or take-up and after
moving the printer.
"Parallel Adjustment" on page 138
U
Is take-up occurring with the printed side
o
facing out?
Take up media with the printed side facing in.
Is narrow media being taken up?
o
We recommend using media with a width of 36 inches
or greater.
Is thick media being taken up?
o
When thick printed media is being taken up, we
recommend setting the print settings of the software
RIP to 3 passes or higher.
Problem Solver

Others

The after heater turns off
automatically
The after heater will turn off if no print job is received
o
for some time and no error occurs. The time before the
after heater turns off automatically can be selected
using the Heat Off Timer option in the setup menu.
"Printer Setup Menu" on page 115
U
The after heater will be reactivated when a print job is
received, the media loading lever is used, or another
operation involving printer hardware is performed.
The control panel display keeps
turning off.
Is the printer in sleep mode?
o
For the SC-F7200/SC-F7100 Series
The printer enters sleep mode when the Heat Off
Timer expires and the heaters turn off. The time
before the after heater turns off can be selected using
the Printer Setup menu.
"Printer Setup Menu" on page 115
U
The after heater will be reactivated and sleep mode
will end when a print job is received, the media
loading lever is used, or another operation involving
printer hardware is performed.
SC-F7000 Series
Press the P button on the control panel to return to
the normal state. The time before the printer enters
sleep mode can be selected in the Printer Setup menu.
"Printer Setup Menu" on page 115
U
The red light is on inside the printer.
This is not a failure.
o
The red light is a light inside the printer.
The administrator password has been
forgotten.
Reset the password.
o
At the Network Setup menu of the control panel, run
Restore Settings, and then set a new password.
"The Network Setup Menu" on page 118
U
129