Tension Measurement; Feeding Tension - Epson SC-F7100 Series User Manual

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
A
Use the d/u buttons to select Roll Type and
press the Z button.
B
Use the d/u buttons to select the desired setting
and press the Z button.
C
After finishing the configuration, press the Z
button.
D
Press the y button to return to the customize
settings menu.

Tension Measurement

Periodically is recommended in most circumstances.
Off is displayed for the SC-F7000 Series only. Choose
Off if slack develops in the media or other printing
problems occur.
A
Use the d/u buttons to select Tension
Measurement and press the Z button.
B
Use the d/u buttons to select the desired setting
and press the Z button.
C
After finishing the configuration, press the Z
button.
D
Press the y button to return to the customize
settings menu.
Feeding Tension (SC-F7200/
SC-F7100 Series only)
Feeding Tension has 2 settings: Auto and Manual. The
default setting of Auto is recommended in most
situations. We recommend setting Manual in the
following situations, and then changing the setting
value.
When the media creases while printing
Set a larger value than the recommended values in the
following table depending on the media width you
loaded.
When banding (horizontal banding, tint
unevenness, or stripes) appears at irregular intervals
in printing results.
Set a smaller value than the recommended values in the
following table depending on the media width you
loaded.
Basic Operations
When the Media Size Check is set to Off
Set the Feeding Tension value as shown in the following
table depending on the media width you loaded.
Media width
162.56 cm
132.08 cm
111.76 cm
106.68 cm
91.44 cm
60.96 cm
If you have previously performed Feed Adjustment, you
will need to perform it again after adjusting Feeding
Tension.
"Feed Adjustment" on page 62
U
A
Use the d/u buttons to select Feeding Tension
and press the Z button.
B
Use the d/u buttons to select the item you want
to change.
Selecting Auto
(1) Select Auto and press the Z button.
(2) Confirm that the checkbox has been selected
and press the Z button.
(3) Press the y button to return to the customize
settings menu.
Selecting Manual
(1) Select Manual and press the Z button.
(2) Use the d/u buttons to set the recommended
value.
(3) After finishing the configuration, press the Z
button.
(4) Press the y button twice to return to the
customize settings menu.
65
Feeding Tension value
Lv28
Lv23
Lv19
Lv19
Lv16
Lv11